Keep your motor cool and your performance sharp with the ultra light weight RC Race Gear Motor Cooling Duct, designed specifically for the Losi 22S Sprint 2WD RC Sprint Car.
This 3D-printed duct mounts directly to the body (not the chassis) using two stock screws and existing holes—no extra hardware or modifications required. Once in place, it acts as a functional scoop, pulling fresh air into the body and directing it over the motor to help reduce temperatures and improve consistency during hard racing.
👉 Installation Note: To allow for better clearance and easier alignment, a small ½" section of the rear body cover should be trimmed. (See product photos for guidance.)
Whether you’re going all out in the A Main or just trying to protect your electronics over long runs, this lightweight, track-tested duct delivers real performance gains with zero hassle.
⚠ This product is independently designed and manufactured by RC Race Gear. It is not affiliated with or endorsed by Losi.
🔵 Key Features:
✅ Compatible with Losi 22S Sprint – Designed to fit the 1/10 scale 2WD Sprint Car (RC vehicle not included)
✅ Mounts to the Body – Attaches using two factory screws through existing body mount holes—no chassis mods required
✅ Boosts Cooling Efficiency – Funnels fresh outside air over the motor to help lower temps and improve performance
✅ Easy Install with Minor Trim – Requires trimming a small ½" section of the rear body cover for best fit (see photos)
✅ Race-Ready 3D Printed Design – Lightweight and durable 3D printed construction built to handle real racing environments
